83 Honda CM 250 C discussion forum: RE: What is the correct belt tension?
Title
RE: What is the correct belt tension?
Entered by
Mark H.
Date
2009-07-30 01:36:11
Alternate method-- Drive belt slack can be checked by hand by lightly pushing up on the lower half of the drive belt midway between the sprockets. Drive belt slack is approximately correct if the belt can be pushed up 15-20mm (0.6-1.0 inches). However, inspection with the drive belt tension gauge is recommended for accurate measurement of drive belt slack. Caution: Drive belt slack inspection should be checked when the belt is cold (before riding). rear axle nut torque 55-65 Nm or 40-47 ft/lbs
We invite you to introduce yourself by a few sentences if you are new to
this discussion group. Enter your e-mail to join the forum and get notifcations on new messages. Or post your question,
answer or comment as a guest. We have just improved this discussion forum and expect the number of users to increase.
More 1983 Honda CM 250 C information
Our discussion groups are intended for short messages. We also welcome more extensive motorcycle reviews.
Bikez also recommends that you check out the technical
data and the riders' rating for the 83 Honda CM 250 C.
You can also rate it yourself. Use our efficient motorcycle
classifieds to sell or
buy
this bike. Your motorbike gets a high quality presentation. Ads are free.
Enter a comment or answer to this message