Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
FZ1 Yamaha/standard
wayne rhodes said 2009-07-27 08:20
Back in march of 09 I bought my FZ1 Yamaha and I really do love almost everything about this bike.Plans are to epoxie the intake ports down a bit for more low end torque. and should not hurt top end because it has three intake valves to breath with.And do some port clean up and add a race five angle valve job.It only has a little over 200 miles on the motor. so I have not spun the motor up past 4500 rpm-when I get my break in miles then I will spin the motor up all out to 12,000 rpm´s. till then happy motoring.ps. why did I buy a standard? you might ask because im 55 years old that´s why good day. WR
You can post your question, answer or comment as a guest. Or
enter your e-mail to join the forum and get notifcations of new messages.
More 2009 Yamaha FZ1 Fazer information
Our discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.
Bikez also recommends that you check out the technical
data and the riders' rating for the 09 Yamaha FZ1 Fazer.
You can also rate it yourself. Use our efficient motorcycle
classifieds to sell or
buy
this bike. Your motorbike gets a high quality presentation. Ads are free.