Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
1975 z1b owner
john dunn said 2008-03-13 14:34
good morning i am rebuilding a 1975 z1b which is bored to the 1135 my question is there is a kv pointless ignition system that i have no idea to set up as the anchor screws are loose. is there a set distance to measure from the sending unit on the crank shaft or do i get it close and use a timing light for 1 and 4 and then for 2 and 3. also i have 400 lift cams with 20 mm. carbs what do i need to set the timing to in ref. to the firing mark. thanks for any help that you may have for me. i could not find a web site for the kv ignition system although i did find a site for the dyna 3 ignition system.
You can post your question, answer or comment as a guest. Or
enter your e-mail to join the forum and get notifcations of new messages.
More 1976 Kawasaki Z1B Z900 information
Our discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.
Bikez also recommends that you check out the technical
data and the riders' rating for the 76 Kawasaki Z1B Z900.
You can also rate it yourself. Use our efficient motorcycle
classifieds to sell or
buy
this bike. Your motorbike gets a high quality presentation. Ads are free.