Or view bikes by:
 - new additions
 - brand
 - year
 - category
 - 50cc or 125cc
 - top charts
New 2014 models New
All 2013 models
MC of the year
News and reviews
Discussions
Words and terms
Unit converters
Riding safety
Home

Free classifieds

Submit motorcycles
Advertise products
Contact Bikez
About Bikez
Privacy Policy
Biker personals




RE: The Triumph Daytona 1200 "and her problems" 95 Triumph Daytona 1200 discussion forum:
RE: The Triumph Daytona 1200 "and her problems"

RE: The Triumph Daytona 1200 "and her problems" 
Martin Greiving (Holland) said 2004-03-20 22:02:30 
 
Triumph Daytona 1200, (common problems)

Rattling or a whining noice indicates that your Balancer Shaft needs adjustment. I drove for a whole year irritated by the whining noice and no Triumph dealer could help me. Solution; At the right side below the crankcase cover there is a clamp with two balancer shafts hold at place by the shaft pinch bolts. Using a flat-bladed screwdriver and make adjustments whilst the engine is idling, noting that only one balancer pinch bolt should be slackened at a time. (rattling=too loosely)& (whining=too tightly meshed).

Bad cold start is still following me but hopefully this week solved by a tip of a veteran. Bad cold start and bad motor performance at high temperatures go together. The pick-up coil can be the problem if wrong readings go to the ignition. Solution; first measure the resistance between the electrical connectors at a environment temperature. This should be arround 530 Ohms +/- 10 %. Than measure the resistance just after a good ride. Motor temp than is arround the boiling water temperature. The pick-up coil is located in the oil stream near the crankcase so it takes the oil temperature. The measurement should give you the same 530 Ohms if not you need a new coil (€ 50,--)If resistance is not the problem the air gap between pick-up coil and rotor trigger could be. Use a feeler blade and if you measure 0.6 to 0.8 mm it is ok.

Performance; as a reaction at the above....yes remove the white pre filters as soon as possible and yes install a K&N filter in combine with a Dynojet-set it works wonders.

Martin Greiving (I´am from the netherlands)
 
 
Answer this message                           Show discussion overview

Comments, questions and answersEnter a comment or answer to this message

We invite you to introduce yourself by a few sentences if you are new to this discussion group. Enter your e-mail to join the forum and get notifcations of new messages. Or post your question, answer or comment as a guest. We have just improved this discussion forum and expect the number of users to increase.
 
Title
 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe by a single click. Bikez does not show, sell or misuse e-mail addresses.
Message text


More 1995 Triumph Daytona 1200 information

Our discussion groups are intended for short messages. We also welcome more extensive motorcycle reviews.

Bikez also recommends that you check out the technical data and the riders' rating for the 95 Triumph Daytona 1200. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free.
    Aprilia     Benelli     BMW     Ducati     Harley-Davidson     Honda     Kawasaki     KTM     Moto Guzzi     Suzuki     Triumph     Ural     Yamaha   

Copyright © 1999-2013 by Bikez.com
Motorcycle catalogue and Motorcycle classifieds