02 Honda CD 125 T Benly discussion forum: RE: Mr bobber benly
RE: Mr bobber benly
timo40 said 2012-09-06 19:06:51
It depends if you want to keep the two shock swing arm, or go to a mono-shock swing arm. Any new swing arm is going to have to be modified to mount the swing arm onto your Benly. I took a swing arm off of a Honda wing. Cut the horizontal swing arm brace in the front of the swing arm. Then had a pipe put inside of this cross brace and welded in the correct position while it was on the bike. Then we halved another pipe that was the same diameter as the cross brace. We welded this over the extension we welded in. We then put a couple of copper bushings in and did the final remount. You will have to have a new brake attachment point welded on to facilitate your brake cable.
We invite you to introduce yourself by a few sentences if you are new to
this discussion group. Enter your e-mail to join the forum and get notifcations of new messages. Or post your question,
answer or comment as a guest. We have just improved this discussion forum and expect the number of users to increase.
More 2002 Honda CD 125 T Benly information
Our discussion groups are intended for short messages. We also welcome more extensive motorcycle reviews.
Bikez also recommends that you check out the technical
data and the riders' rating for the 02 Honda CD 125 T Benly.
You can also rate it yourself. Use our efficient motorcycle
classifieds to sell or
this bike. Your motorbike gets a high quality presentation. Ads are free.